Hydraulic Brake Pressure Transducer let's you set up your AC drivetrain for the ultimate feel in regenerative braking
1. Specify 1/4 NPT or 1/8th NPT connection to existing hydraulic brake system.
2. Two foot cable with connetions for 5v power (red) ground (black) and signal (white).
3. 500 psi gauge presssure
4. 0.5 to 4.5v output
5. Withstands pressures to 1500 psi.
This transducer can be used as the brake input for the Curtis 1238 controller inlcluded with the AC50 kit. This allows you to use
brake pressure to modulate your regenerative braking on the Cutris Controller.
Controller Pin 27 for 5v (red)
Pin 17 for signal (white)
Pin 18 for return (black)
Variables in the controller allow you to adjust how this feels.
Works with almost any system that uses 3-phase AC motor drive train and provides regenerative braking.
No Reviews For This Product.