New CALB CAM72FI Cells.
Introduced May, 2014. Higher volumetric and gravimetric density for much smaller lighter packs. As much as 40% smaller and 20% lighter than the CA series cells.
These are similar LiFePo4 chemistry at a nominal 3.2 volts. These cells are 72 Ampere Hours. Features an aluminum alloy shell.
Nominal Voltage: 3.2v
Charging Voltage: 3.65v
Typical Voltage after charge: 3.36v
Capacity: 72 Ah
Height: 218 mm / 8.58 inches
Width: 135 mm/ 5.315 inches
Weight with strap: 1.95kg/4.3 lbs
Volume: 0.8829 liters
Gravimetric Density: 118 Wh/kg
Volumetric Densityh: 260 W/ltr
Cycle Life: >2000
Continuous Discharge: 2C - 144 amps
30 Second Discharge: 4C - 288 amps
10 Second Discharge 8C -576 amps
Charging Temperature: 0-45C
Discharging Temperature: -20 to 55C
Face to face strap size: 30mm
Order additional 70mm straps for side-by-side (edge to edge) connections
CA SERIES CELL USE AND CARE MANUAL - English
CA SERIES CELL USE AND CARE MANUAL-French
CA SERIES CELL USE AND CARE MANUAL-Portuguese
OPTIONAL BATTERY STRAPS
Order 30 mm battery straps to interconnect cells. Each strap includes tinned braided strap, two stainless M6-12 capscrews, and two Nordlock zinc coated XP series conical wedgelock washers. This is correct strap for face to face connections of cells.
To connect cells ADJACENT or edge-to-edge, order 70mm straps separately in Battery Connection Section
BATTERY SHIPPING CHARGES
This online store software will calculate shipping charges to a commercial address where no liftgate is required. This calculation includes a $30
HAZMAT fee we must pay to ship cells.
If you are shipping to a residential address, You will be notified and
can pick up your cells at the UPS terminal.
If you need delivery to a residential address, there is an additional fee of $240 per shipment for residential delivery with liftgate.
You can avoid liftgate charges by selecting DELIVERY TO NEAREST TERMINAL. You will be notified when they arrive and will need to arrange to pick them up at the UPS terminal.
NOTE: The exterior of this cell is aluminum and is tied to the positive terminal of the cell. Battery boxes MUST be insulated and insulation must be installed between each cell in a battery box.