Login Status  Login Status

Not logged in

» Login
0 Product(s) in cart
Total $0.00
Online Payment Service

Home » Tesla Model S Full Battery Pack

Control Module for Tesla Model S Battery Pack
1 of 7

 This control module allows you to use a Tesla Model S Full battery pack as an 85kWh energy storage device for your solar installation.  It communicates with the Tesla Battery Management System and allows you to control contactors and set limits for voltage, temperature, and cell variance and to control external charge controllers to charge the pack from a solar array.


Price: $2,395.00
Add to cart
1 of 2
The EVTV Controller Area Network (CAN) Geopositioning Satellite System receiver receives positioning information from the GPS satellite system and converts it to CAN data frames for use on automotive and marine systems.

It provides data in CAN 11-bit or 29bit format at any CAN data rate.

1.  Speed in whole statue miles per hour.
2.  Direction of travel -Course in degrees to 2 decimal places.
3. Odometer - statute miles travelled since last reset.
4. UTC time hours/minutes/seconds to act as  real time clock
5. Lattitude and longitude to six decimal places (ie 37.123456)

Price: $199.00
Add to cart
6.6kW High Voltage Charger
1 of 6
 This is the new 6.6kW output Elcon/TCCH CAN controlled charger for batteries 110 to 440vdc. We were wowed by this in testing.  Air cooled, but the fans are so quiet you can hardly hear them.  And after 30 miinutes at 6500 watts measured output, the heat sink was not even warm to the touch.  Very cool.  Very efficient.  And now in a very OEM style aluminum enclosure with high quality connectors.  This device is CAN controlled and our Tesla Full Battery Pack controller will control it perfectly for AC grid supplement of energy to your Tesla full battery pack.

OR we suppose you could use it in an EV.  This little powerhouse is a tiny 14x9x5 inches and 24 lbs, nearly silent, runs very cool, and puts out the full 6.6kW advertised to charge twice as fast as the previous generation - at half the price.

If you are not using our Tesla Battery Pack Controller, you will need the optional TCCH CAN controller.
Price: $1,890.00
Add to cart

JSR 16 inch 200Watt 120v Heating Pad
1 of 2
 16 x 16 inch silicone rubber heating pad with adhesive backing.  120vac, 200 Watts.  Works well to heat Tesla Battery.
Price: $139.95
Add to cart
8-port RJ-45 Patch Panel
1 of 4
This is a well built little patch panel box with metal enclosure.  We punch down pin1 (ground), pin 4(CANHI) pin 5(CANLO) and pin 9 (12v) to match our scheme for carrying CAN and 12v power over CAT5 cables for the EVIC display, 6.6kw chargers, CAN GPS Real Time Clock module, and future enhancements to our battery controllers.  This little box let's you easily and conveniently plug in a display, two or three chargers, etc all with access to the battery controller CAN bus.
Price: $89.00
Add to cart