SOLID STATE DC RELAY
This is a solid state DC relay for switching DC currents of up to 80 amperes at voltages from 5vdc to 220vdc. A small red light indicates when it is on.
These work like mechanical relays but without the contact life issues. Control voltage from 3-32vdc causes it to connect the two terminals. This control voltage draws less than 25 ma. You could actually use a bare Arduino or Macchina output to switch voltage.
We use these to switch DC voltages to heating elements in place of a Tyco Kilovac contactor. Used with the JLD612 temperature controller, there is really no life limit to the number of cycles using this device, nor contact wear from breaking currrent flows repeatedly.
Load Current: 80A peak load, 40 amperes continuous
Load Voltage: 5-220V DC Actual (24-220V DC MArked)
Control Voltage: 3-32V DC
Control Current: 5-25mA DC
On Voltage: ≤2.3VDC
Off Leakage Current: ≤2mA
On-off Time: ≤10mS
Dielectric Strength: 2000VAC
Insulation Resistance : 500M ohm/500VDC
Ambient Temperature.: -30℃～75℃
Working indicators: LED