SOLID STATE DC RELAY
This is a solid state DC relay for switching DC currents of up to 10 amperes at voltages from 5vdc to 220vdc. A small red light indicates when it is on.
These work like mechanical relays but without the contact life issues. Control voltage from 3-32vdc causes it to connect the two terminals. This control voltage draws less than 25 ma. You could actually use a bare Arduino digital output to switch up to 10 amps of current..
Load Current: 10A peak load, 5 amperes continuous
Load Voltage: 5-220V DC Actual
Control Voltage: 3-32V DC
Control Current: 5-25mA DC
On Voltage: ≤2.3VDC
Off Leakage Current: ≤2mA
On-off Time: ≤10mS
Dielectric Strength: 2000VAC
Insulation Resistance : 500M ohm/500VDC
Ambient Temperature.: -30℃~75℃
Working indicators: LED
Certification: CE